6 bag kit includes:

• 4 disk bases
• 4 poles (2 poles come with light adapters on top for display lighting accessories which are sold separately.)
• 1 1500mm graphic cassette
• 2 1000mm graphic cassettes
• 12 graphic cassette⁄rail hangers
• 3 graphic tension keys

Unscrew wing-nut located at the bottom of each pole.

Attach one pole to one disk base with wing-nut. Repeat for remaining poles.

Note: Only if you will be displaying graphics at 90˚ angle, you must add an additional graphic cassette⁄rail hanger to slots at the bottom of pole before base is attached to pole. (See step 4)

Insert graphic cassette⁄rail hangers in the slots at top of poles where you want to position graphic cassettes.

Adjust poles to desired height by using the release buttons on sides of poles.

Hang the graphic cassettes by inserting the opening at the end of cassettes over the graphic cassette⁄rail hangers on the top of poles.

Pull graphic from cassette by rail edge to extend down to the graphic cassette⁄rail hanger located on pole at base.

Fasten graphic rail edge to hanger at bottom of pole by inserting the opening at the end of rail over the hanger.

Graphic tension key is supplied to apply tension to graphic cassette.